[honhon]

Sense this has to do with the front bumper, I thought it would be best suited here...

but anyways, I noticed the top of the bumper area has 4 10mm bolts... and I was wondering, for quicker access if anyone has the idea of using these instead?

TRACKSIDE - Nylon Push Rivet - Nuts & Bolts - Tools - Accessories - Cycle Gear

 

[honhon]

no one also had this idea? lol

 

[Forte5]

I replaced mine but not with these. I put a dress up bolt kit that is stainless hex key bolts with red washers. The bolts are counter sunk into the washers. I am not to worried about quick access to much lol

You can see in this pic one of them towards the top right.

https://www.dropbox.com/s/ci1ko60fut91icy/20141119_195931.jpg?dl=0

 

[honhon]

well I was thinking of it because 3 bolts went back in fine, but the 4th feels like it tightened itself and ground the threads... so I was thinking of just doing this. it doesn't seem like there would be an issue but I was just curious

 

[Forte5]

I dont think there would be a issue also. It is a really good idea to. If i needed to take my bumper off all the time i would do it

 

[honhon]

resurrection from the dead... i ordered some bulk ones off ebay just to try out. if it works well enough im going to make a video for my channel

 

[Caezar]

It would make it super easy and quick to get it on and off lol . Took me destroying 3 on my old car to figure out how to take them off and put them back on . But once I did made taking panels off the car a lot easier . Let us know how it goes for sure . My only fear is down force would pull them out .

 

[2014:1.6lT]

Lol same with mine, 3 went in good, the 4th wasn't so smooth...