Kia Forte Turbo Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter · #1 ·
Where is everyone running their wires for a mechanical boost gauge? I have the vacuum block from 6th, but i have no experience with anything electrical on these vehicles. Just want to know what you are tapping into with all your connections thanks!
 

·
Registered
Joined
·
1,697 Posts
You run them through the plastic/rubber boot in the firewall behind battery.

I do not have a picture now, but there is only one.

It seems to be rubber only, but there is a plastic shield in it, so a small drill bit helps.

EDIT:
I found it.
20160424_151801.jpg
 
  • Like
Reactions: mr_sippi_forte

·
Registered
Joined
·
1,697 Posts
Where did u guys tap the wiring too I'm try to hook mines up but I don't know any electricity
What gauge do you have?

If you have mechanical, which is the preferred way, you do not need any electricity, except the light.
If electric - well, depends what you got, but it will be always more or less messy as boost comes from MAP sensor.
If you have own transducer, tap it using a vacuum block.
 
1 - 5 of 5 Posts
Top